Application Instructions

Application Instructions

1. Clean surface where vinyl is to be applied and allow to dry.

2. Leaving the decal face down on a table carefully & slowly remove backing. If some of decal sticks to backing, re-attach and turn decal over so transfer tape side is up and rub smoothly over surface with squeegee or credit card.

3. Place decal carefully on surface and using a squeegee or credit card apply pressure moving from the middle/inside towards the outside to push out all air bubbles. Make sure decal is straight before applying.

4. With squeegee, credit card or driver's license, rub once again. This will ensure decal will stay on window (or surface area applying it to).

5. Carefully remove application tape. Pull the tape back over itself. If bubbles appear, Squeeze them out to the edge, or puncture a pinhole and squeeze air out

For larger decals (10 inches or more)

1. Clean surface where vinyl is to be applied and allow to dry.

2. Lay decal on table then pull back wax paper liner a few inches then fold the paper liner.

3. Line up exposed part of decal on surface, making sure that the part of the decal that is still protected by the paper liner is lined up also, then press down exposed part of decal firmly. Using squeegee or credit card smooth over transfer tape and decal toward the center. Once initial few inches are in place pull paper liner a few more inches, and squeegee down toward center. Repeat until entire decal is in place.